Skip to content
Küche Chef homeShop on Amazon (opens Amazon)
Menu

How-to guide

How to rescue a rusty or thrifted cast iron pan

A rusty pan from a yard sale or a grandparent's cupboard is rarely beyond saving. Scrub, wash, dry and season it again, and it is ready for the family table.

By Küche ChefUpdated 4 min read

An empty cast iron skillet resting over a small fire outdoors
On this page

The short answer

Scrub the rust off with warm soapy water and a scrubber until you reach bare gray iron, then wash, dry the pan straight away and season it again in the oven. Lodge describes this same scrub, wash, dry, oil and bake routine, and says rusty cast iron is easy to restore.

What you need

Step by step

  1. Look the pan over

    Check for deep cracks, a wobble when it sits flat and rust that is only on the surface. Surface rust and old stuck-on grime can be cleaned off. A pan that is cracked through is better kept as a plant pot.

  2. Scrub off the rust

    Lodge says to scour rusty cast iron with warm, soapy water and a metal scouring pad. Keep going on the cooking surface, the sides and the handle until you see bare, gray iron. The chainmail scrubber helps with stuck-on bits in corners.

  3. Wash and rinse well

    Wash the whole pan, inside and out, with a little Cast iron pan soap and warm water, then rinse. It is fine to use soap now, because you are about to season the pan again.

  4. Dry it straight away

    Dry the pan with a towel, then set it over low heat for a few minutes so every drop of water is gone. Bare iron can start to rust again quickly, so do not leave it to air dry.

  5. Oil it, then wipe it back

    Rub a thin layer of Cast iron oil over every surface, including the handle and the underside, then wipe it back with a clean towel until the pan looks almost dry. Lodge says the layer should be thin enough that oil does not drip or run when you tilt the pan.

  6. Season it in the oven

    Lodge's seasoning guide has you bake the pan upside down on the center rack at 450 to 500°F for one hour, with foil on the rack below to catch drips, then let it cool in the oven. Our full method, with six coats, is in how to season cast iron cookware.

  7. Cook, and keep it up

    Start with something fatty, like bacon or sausages, and wait on tomato sauce for a few weeks. After each wash, dry the pan over low heat and wipe on a thin layer of Cast iron conditioner.

Tip:Take your before photo first. The change is the most rewarding part of the story, and you will want to show the family.

Warning:Do not leave a pan soaking in water while it waits for its turn. Standing water brings rust back within hours.

When a pan is not worth saving

A crack, a pan that rocks badly on a flat surface or deep pitting across the cooking surface mean a pan will not cook well. Everything short of that is usually worth a rescue.

If you are not sure about an old pan, ask whoever sold it where it has been kept. A pan that sat in a damp shed will have more rust than one stored in a cupboard, but both can be cleaned.

Common questions

Can you restore a very rusty cast iron pan?

Usually, yes. Lodge says it is easy to restore rusty cast iron: scour it with warm, soapy water and a metal scouring pad, then season it again.

Is it safe to cook in a pan that had rust?

Once the rust is scrubbed off down to bare iron and the pan is seasoned again, it is ready to cook in. If any rust remains, keep scrubbing first.

Do I need to strip an old seasoned pan before I season it?

Only if the old seasoning is flaking or sticky. Lodge suggests scrubbing flaking seasoning with a nylon brush or salt, then oiling, and seasoning in the oven if it keeps flaking.

Can I use the chainmail scrubber for rust?

It lifts stuck-on food well. For heavy rust, start with a metal scouring pad as Lodge suggests, then use the chainmail for the finishing wash.

Sources